Step By Step Making Crossover Cable

How to make Step By Step Making Crossover Cable,
What you need to make Crossover Cable
Cable - Be sure the cable(s) you are using is properly rated for CAT 5. It should state clearly on the jacket of the cable, what it is rated at. One option that you have when selecting your cable is to use a pre-made normal 'straight through' cable, and simply whack off one of the ends, and replace with a new "Crossed Over" end. For the purpose of this article, though, we aren't going to go that route. We are going to make the whole thing from scratch - using bulk CAT 5 cable.

ns 3 & 6 from the first end are connected to pins 1 & 2 on the other end. Pins 4 & 5 and 7 & 8 don't change.



Connectors - Crossover cables are terminated with CAT 5 RJ-45 (RJ stands for "Registered Jack") modular plugs. RJ-45 plugs are similar to those you'll see on the end of your telephone cable except they have eight versus four contacts on the end of the plug. Also, make sure the ends you select are rated for CAT 5 wiring. There are also different types of jacks which are used for different types of cabling (such as Solid Core wire). Make sure you buy the correct jacks for your cabling.

Crimper - You will need a modular crimping tool. My advice on what brand to get? Well, I really don't have a preference at this point, but make sure you buy a good one. If you spend about 40 to 50 bucks, you should have one that will last ya a lifetime. Spend 10 to 20 bucks, and you might be able to make a few cables with it if you're lucky. You definitely get what you pay for when it comes to crimpers!


The pinouts looking from the bottom of the cat 5 ends (White/Orange starts on the left) are as follows:

Standard End                          Crossover End

Pin 1 White/Orange                   Pin 1 White/Green

Pin 2 Orange                         Pin 2 Green

Pin 3 White/Green                    Pin 3 White/Orange

Pin 4 Blue                           Pin 4 Blue

Pin 5 White/Blue                     Pin 5 White/Blue

Pin 6 Green                          Pin 6 Orange

Pin 7 White/Brown                    Pin 7 White/Brown

Pin 8 Brown                          Pin 8 Brown



Stripper - No I'm not talking about what Spot had at his bachelor party, I am talking about a tool to strip the ends off the wires you pervert! There are several specialized tools, which can be used to strip the jackets off of cabling. If you do not have access to one of these tools, cautious use of a razor blade or knife should work just fine - but keep in mind if you go the razor blade / knife route, extra special care must be used as to not damage the wires inside the jacket.

Cutters - You need a pair of cutters that will allow you to cut a group of cables in a straight line. It is very important that all the wires are the same lengths, and without proper cutters, this can be a difficult task.
Bookmark and Share
My Zimbio
> TopOfBlogs .sg   TopOfBlogs